Cross Hatch Cutter Adhesion Test Kit – CC1000 Range

The Cross Cut Adhesion Test Kit CC1000 is used to test the adhesion of dry coats of paint on their substrate by means of a series of cuts through the coating. Two series of parallel cuts cross angled to each other to obtain a pattern of 25 or 100 similar squares. The ruled area is evaluated by using a table chart after a short treatment with a stiff brush, or adhesive tape for hard substrates.

The round cutting knife of the Cross Cut Adhesion Test Kit CC1000 has eight cutting edges that can be changed easily by rotating the knife. The self positioning knife bracket of the Cross Cut Adhesion Test Kit (CC1000) ensures equal pressure on the cutting knife.

 

Related Products:

 

Directions for use:

Simply make a cutting pass through the coating to the substrate, this will leave 6 parallel cuts in the coating. Then make a second pass at 90º to the first to make a square lattice pattern.  Apply a length of adhesive tape over the lattice pattern & remove tape within 5 minutes.  You can then classify the test area using the supplied magnifier to the relevant national standard.

ISO 2409:

  • 1 mm. spacing for coatings up to 60 µm on hard substrates
  • 2 mm. spacing for coatings up to 60 µm on soft substrates
  • 2 mm. spacing for coatings from 61 to 120 µm on both hard and soft substrates
  • 3 mm. spacing for coatings from 121 µm to 250 µm on both hard / soft substrates

ASTM D3359:

  • 1 mm. spacing for coatings up to 50 µm
  • 1,5 mm. spacing for coatings from 50 to 125 µm

Packing List:

  • Cross Hatch Adhesion Tester with Round Head Cutting Knife
  • Brush
  • Illuminated Loupe
  • Roll of Adhesive Tape to ISO 2409

Enquire

Order CodeDescription
Cross Cut Adhesion Test Kit acc. to ISO 2409 , 6 teeth
55-VF1839CC1000 cross-cut tester 1mm ISO 2409
55-VF1842CC1000 cross-cut tester 2mm ISO 2409
55-VF1844CC1000 cross-cut tester 3mm ISO 2409
Cross Cut Adhesion Test Kit acc. to ASTM D3359, 11 teeth
55-VF1846CC1000 cross-cut tester 1mm to ASTM
55-VF1847CC1000 cross-cut tester 1.5mm to ASTM

 

Enquire

Order CodeDescription
70-K0001539M002ISO2409 adhesive tape (1 roll)
70-K0001539M001ASTM D3359 Adhesive Tape (1 roll)
55-VF2359ASTM Spare Knife only 1mm
55-VF1861ASTM Spare Knife only 1.5mm
55-VF2355ISO Spare Knife only 1mm
55-VF2357ISO Spare Knife only 2mm
55-VF2358ISO Spare Knife only 3mm